Brutus
CGN Ultra frequent flyer
Hello fellow BP enthusiasts.
Was wondering if Pietta or Uberti 1849 owners could please do me a favor?
Could you please disassemble your fine revolver(s) and measure the arbour diameter of your revolver?
Edit: I understand often, these are actually tapered? 3 or 4 measurements??
And while you are at it, the outside diameter and length your 5 shot cylinder?
Muchly appreciated!
PS: my Manhattan arbour is 0.3050 near the front and 0.3385 in the end.
Was wondering if Pietta or Uberti 1849 owners could please do me a favor?
Could you please disassemble your fine revolver(s) and measure the arbour diameter of your revolver?
Edit: I understand often, these are actually tapered? 3 or 4 measurements??
And while you are at it, the outside diameter and length your 5 shot cylinder?
Muchly appreciated!
PS: my Manhattan arbour is 0.3050 near the front and 0.3385 in the end.
Last edited:
