.270 Win Bullet Question

Reflex_84

Regular
Rating - 100%
92   0   0
Location
Alliston, ON
I know this has probably been beat to death, but I'm having a hard time searching this one out.

A store near me has some .270 Win Hornady Light Mag 140 gr Interlocks for sale at $33 a box.

Would you feel confident using this combo on moose and black bear? What is the Interlock comparable to? Is is like a Cor-Locked? Or is it bonded?

Thanks for your insight. Any advice is appreciated.
 
You can get all the details of that bullet at the Hornady website.
It isn't bonded, the "lock" is the grove pressed into the bullet to prevent the lead from slipping out of the jacket.

The boned bullets are premium and approx 2X the price, but better weight retention.
 
this may be off some help.

http://www.rifleshootermag.com/ammunition/best_biggame_bullets/index1.html

That review is so old,many of the bullets aren't even in production anymore,and there are now many more high quality bullets that didn't exist at the time that review was done.
 
I would not use the Interlock for moose. I don't think it will give enough penetration. The bull I shot with a 270 was with a Nosler Partition and broadside at 50 yds even that bullet did not pass through.

Hugh
 
My choice for moose in my .270 is a 150 grain Nosler Partition. I would think there are other "premium" bullets that would work, just no experience to go on. I am experimenting with Barnes TSX bullets looking for the best load, and they are looking good for large animals too. You need all you can get out of a .270 for moose.
 
I've shot moose and other big game with normal cup-and-core 130's and 150's no problem. Just make sure you put your bullets straight into the boiler - if you're a front shoulder shooter then go with a bigger caliber.
 
I'd buy them for load development, target practice, plinking, and hunting deer and bear. I'm sure they'd make a moose dead but I'd spring for some Accubonds, Partitions or Barnes TSX.
 
I have mentioned this incident on a forum here previously, but for the benefit of those who have not seen it, I'll repeat. I was Whitetail deer hunting with a Remington 700 chambered in 270 Winchester. I was shooting the 140 Hornady 140BT Interlock because It was very accurate in this particular rifle. I was on a post in the evening, and a 4x4 Whitetail buck showed up at approximately 80/90 yards, broadside. I levelled the crosshairs and touched one off. The deer jumped sideways and then took three or four jumps in behind a few willows, then stopped and stood there, looking uncomfortable. I managed to find a "hole" through the willows and sent another shot on it's way, at which the deer obligingly dropped. The postmortem showed that the first shot had hit a rib at entry, and had disintegrated, with shrapnel travelling in several directions. [I later found a piece of the jacket in the flank, and one in the neck.] The second shot had penetrated completely, and was the shot that killed that deer [Dressed weight 142 lbs]
Whether the bullet was simply a "bad" one or not, I stopped using that bullet ojn game, and went back to the Partition, a bullet I have proven on game over time. I would never use that 140 on moose or elk after such an experience. Not knocking Hornady here, they make many fine offerings, but that particular bullet is on my "don't use on game" list. Regards, Eagleye.
 
Back
Top Bottom