3/8" to picatinny adapter

S

smity199

New member
EE Expired
Rating - 100%
1   0   0
Hey Im looking for a 3/8"(11mm) to picatinny(weaver) adapter thats less than 6 inches long, I want it to replace the rear sight on my mosin nagant. when removed it leaves an 11mm dovetail but i want to mount my bushnell trs-25 which requires weaver mount, ive seen adapters online but none that will ship to canada:bangHead: does anyone know if or where I can get one of these? thanks
 
I'm using Kwik-Site mounts on my grooved .22LR. It mounts a red-dot just fine and holds zero. I can't vouch for their use on a centerfire, but at $14.99, no loss if they don't work... just buy a .22 to use them on :p

http://www.cabelas.ca/index.cfm?pageID=71&&section=1195&section2=1377&ID=9857
 
The B square should work and you can always trim it down if it's too long...
Sold out of Vancouver.
http://www.dlairgun.com/B-Square-Mounts.html
BKL also makes one that is a bit pricier and I'm not sure if it's good for 11mm but D&L could answer that question..
http://www.dlairgun.com/BKL-Mounts.html#
 
Hey thanks everyone for the replies, Im going to order that B square adapter and hope some loctite will help it hold up to the recoil.. thanks
 
I have been searching for the same thing. Just found what I was looking for at a Canadian site.

htt p://scopesandammo.com/storefront/index.php/scope-ringsrailsmounts-mount-adapters-c-37_63
 
You must log in or register to reply here.
Back
Top Bottom