Recently aquired a 338 edge and seeking some advice on how to bump the shoulder using 338 rum dies.
I have a 338 edge neck sizing die, a 338 rum FL die, and a 338 rum seater die.
Does anyone have experience using 338 rum dies to re-size 338 edge brass?
This was a used buy so I have lots of fireformed brass and some virgin 338 edge brass.
Thinking of just neck sizing but since this will be a hunting rifle I'd like to try bump the shoulder of the brass a little.
Any help would be appreciated. Thanks !
I have a 338 edge neck sizing die, a 338 rum FL die, and a 338 rum seater die.
Does anyone have experience using 338 rum dies to re-size 338 edge brass?
This was a used buy so I have lots of fireformed brass and some virgin 338 edge brass.
Thinking of just neck sizing but since this will be a hunting rifle I'd like to try bump the shoulder of the brass a little.
Any help would be appreciated. Thanks !
