.350 Rem Mag.

[Steyrtac]

Hi there!

What are your pet loads for the .350 Remington Magnum?

Your favorite bullet weight/design?

Your favorite source for brass and loaded ammo?

What kind of rifle did you use?

I found some boxes of Nosler ballistic tip 225 gr. but the boat tail design gave a bullet too long for my Rem mag...? True or false?

Regards,
Eric

 

[dan belisle]

250 gr Speer or Hornady, 4064 or 4320 for powder (depending on the bullet). I don't get great accuracy from the 225 in my rifle, so I stick with the 250. - dan

 

[AP]

I have had good luck with 65gr of H380 200gr Hornady Spire Pt R/P brass CCI 200 Primers 2844fps and good accuracy (eg under 1 1/4 at a 100 yd)

also 60gr of IMR4320 225 Gr Nosler Partition CCI 250 primers R/P brass 2625fps and pretty good accuracy (eg under 1.5inch at a 100)

 

[stanway]

So far my Ruger likes:

225gr Partitions with 56.0gr of IMR4064
200gr Hornady SP with 56.0gr of IMR4064
200gr Hornady SP with 60.0gr of IMR4320

I bought Remington brass and use Fed 210 primers.

I will be using the 225gr for moose this year (and mule deer hopefully ).

Good luck.

 

[350 Mag]

I shoot a Remington M600 and my best so far is Speer 250 Spitzer over top 54 gr. of IMR 4320 with a CCI magnum primer.

This load will shoot less than 1 inch at 100 yards if the shooter does his/her part...

I have been wanting to try some 225 Swift A-Frames though