375-338WM finish reamer??? Advice plz

[Big bore dinosaur]

I'm looking to clean up my chamber, looks like there's a little chatter in the side walls of the chamber, 6 sides
Gunsmith mention, should be fine to shoot, just need to full lenght size your brass . Giver a try .
He has seen worse shootnjust fine and group
If she groups your good. Save your money

But the OCD side figure just buy a reamer o r get the barrel reamed out by another Smith,, and start out right
the first go around.

Any lead CGN gunnies.? Gunsmiths or reamer available yall know about.

Thx for your time

 

[guntech]

Once a chamber has chattered it may require a lot of the new reamer to get through the chatter... not just a few thou usually.

 

[billdick]

I had a chatter wreck once and Denis gave me a couple hints to fix it. I had to go about 3/16 of an inch or better to fix it. Worst part is it started to chatter a couple thou from done. It was a bunch of work but I got it cleaned up using the same reamer I started with.

 

[Slimbo]

Maybe go 375 ruger, that will clean it right up

 

[Big bore dinosaur]

Thx guntech and billdick , agreed

Not interested in 375ruger..
No brass available at reasonable prices
I'll keep searching for a new reamer

 

[billdick]

Is the reamer that cut the chamber buggered? The 375-06 reamer that started to chatter on me had no damage and I used it to fix the issue.

 

[Big bore dinosaur]

Hey there bill.
I purchased the rifle used, from a collection .
the gentlemen who passed while back, rifle was not finished
The 375 338 win reamer didnt come with the reamer unfortunately
I found that Pacific tooling has 375 338win for sale 200 usd

 

[billdick]

Ok I get it. Dave Manson may have a reamer. Check him out.

 

[guntech]

I would rather own a Manson reamer over a PTG.

 

[Big bore dinosaur]

Ok I get it. Dave Manson may have a reamer. Check him out.

Thx fellow gunnies, will do