610 yards cold bore shot

[Clayne_b]

 

[Dogleg]

.308?

 

[Clayne_b]

Yes.

 

[Dogleg]

Gun got a story?

 

[Clayne_b]

It is a factory Remington 700 SPS Varmint .308

Timney 510 trigger
Mcrees Precision Stock
DIY bolt knob
Black hawk rings and rail
Vortex 5-15x44 Mil Mil scope. Vortex bubble.

Haven not cleaned it in around 600 rounds and it shoots VERY GOOD

Here are 2 Three shot groups at 510 yards I shot last week

 

[Dogleg]

Cleaning is over-rated. What did you coat it with?

 

[Clayne_b]

Just spray paint

 

[KDX]

Cleaning is over-rated. What did you coat it with?

Lots of truth there.

 

[Gun5tuff]

Your bullet hit the ground within the area covered by the camera. That was very good.

 

[Grizzlypeg]

I don't understand the video. What was the target? How did the cold bore shot deviate or not from point of aim?

 

[jimmyjazz]

I don't understand the video. What was the target? How did the cold bore shot deviate or not from point of aim?

That's what I was wondering ... ???

 

[ultimate_monkey]

I don't understand the video. What was the target? How did the cold bore shot deviate or not from point of aim?

im assuming the target was the rock in the center of the screen, the one that got shot obviously, as far as how the CB shot deviated for that rifle i cant say, but generally speaking the 1st shot in a cold bore generally deviates form once the barrel is warm. if you know where your CB shot is, then this isnt that hard to figure out. Ex - my 308 shoots almost 1moa low on a cold day for the 1st shot, 600yds = 6" low read wind, aim over 1moa extra for 600. bam 600yd CB

not trying to take any thing way from Clayne here...

 

[Shibby!]

Looks good.

Now if you want to claim group shots compete in the 1/2 and 3/4 MOA challenge thread

=)

 

[moosehunter]

Thats an amazing group for a factory barrel. Youve got a keeper there.