7mm Rem Mag - all bark, no bite

I don't have the data for my old RH Rem 700 LSS in 7mm Rem Mag with a 24" barrel anymore...so cannot provide any details as to its performance with its preferred ammo; Federal premium 165 gr SGK. Too bad this ammo has been long discontinued! It performed well on game including elk, mule deer, mtn goat, and moose. Sold it to get the LH version when introduced, but couldn't get the 7mm Rem Mag and ended up with a 270 Win.

My last 7mm Rem Mag was a LH Browning X Bolt All Weather with a 26" barrel. It performed as follows:
  • Federal Terminal Ascent 155 gr ammo spec'd at 3000 fps produced 3156 fps and 3 shot groups of .902" @ 100 yards
  • Federal Trophy Bonded Tip 160 gr ammo spec'd at 2900 fps produced 3009 fps and 3 shots groups of .858" @ 100 yards
  • Nosler AccuBond 160 gr ammo spec'd at 2925 fps produced 3116 fps and 3 shot groups of .580" @ 100 yards
Shouldn't have traded it for the same rifle in 308 Win, but I wanted a donor for the 25 CM, and I have a LH Fierce Carbon Rogue in 7mm PRC now that produces 2920 fps from the 24" barrel with the Federal 170 gr Terminal Ascent ammo, and 3 shot groups of .708" @ 100 yards. While being slower, the higher BC retains almost the same velocity as the lighter version in the Terminal Ascent bullet, but retain more than 200 ft lbs more energy out at 500 yards, so it will work just fine for me on the elk at the distances I shoot them.

In the end, my experience with the 7mm Rem Mag has been good. I have no complaints, and would not hesitate to buy another Big 7 in a make and LH model that tweaked my interest!
 
So not the rifle/barrel, just poor ammo from federal.
Well, I don’t know about that. His rifle has counter clockwise fluting, which is the opposite of standard right-hand twist. Everyone knows about barrel harmonics- it’s why pressure points, free floating and full length bedding affect accuracy.

So when you have fluting going in the opposite direction of rifling, it interacts with the barrel harmonics and causes drag. Think of it this way, when you flush the toilet the water spins in a certain direction and INCREASES velocity. That’s your rifling. Now flush the toilet again but this time block the spinning water with your hand moving in the opposite direction of the spinning. It will DECREASE velocity.

Same thing is happening here.
 
N560 will push 175gr at a touch under 3000fps
So will r26 if it can be found but I haven’t used grand yet
I stumbled on Grand when I was looking for a substitute for RL26.
I'm getting about 3000 with a 175 gr partition, and 3180 with a 160 partition. Hornady 154 flat base get half a grain more powder, to produce 30 fps less velocity. Rifle was a first-year Rem 700, 23 1/2" barrel.

I was disappointed in factory ammo, but it wasn't as dramatic as the OP. About 2900 with a 150 Remington, and 2700-ish with a 175 gr Rem. I can get that from a .30'06 with a shorter barrel and less powder.
 
  • Like
Reactions: DGY
Well, I don’t know about that. His rifle has counter clockwise fluting, which is the opposite of standard right-hand twist. Everyone knows about barrel harmonics- it’s why pressure points, free floating and full length bedding affect accuracy.

So when you have fluting going in the opposite direction of rifling, it interacts with the barrel harmonics and causes drag. Think of it this way, when you flush the toilet the water spins in a certain direction and INCREASES velocity. That’s your rifling. Now flush the toilet again but this time block the spinning water with your hand moving in the opposite direction of the spinning. It will DECREASE velocity.

Same thing is happening here.

ChatGPT is gonna repeat this to someone as if it's factual lol
 
Oh boy….dont want to take that one to the northern border. It doesn’t kick enough!

Its downloaded beacause of the wussification of society

Anyone who thinks 6.5cm is not enough for deer at 120yds is a hack and a fraud. Better not tell him about the 243, or #### any of the straight wall cartridge options that are legal in shotgun zones in some states.

Helps if your family tree is lacking branches, I imagine.
 
Last edited:
  • Like
Reactions: DGY
Back
Top Bottom