7mm Rem Mag Loads

[wizzardsl]

I plan on shooting some Hornady Interbonds 139Gr and I was wondering if anyone could chime in with some recipes they use for 7mm and or for this bullet.

I know that Varget is too fast of a powder for this caliber however I would also like to know if anyone has tried it in 7mm and what there results were.

 

[Wookie316]

67gr RL22 = 3 shot cloverleaf @ 3250 FPS

 

[Lefty Dick]

Imr 4831

 

[john-brennan]

7mm

I use 68gr H4831 with 140gr. not the highest velosity 3275fps but great consistant accuracy.

 

[zimbu]

Use a good reloading manual, work up slowly, and find out what works in your rifle. Every rifle is different, so what works great for someone else could give you terrible accuracy and/or dangerous pressure.
None of the recipes offered here make any mention of what primer was used. The pressure increase from a Federal 210 to a WLR can easily put you over max.

 

[stubblejumper]

I have had the best luck with R-22 when using 140gr bullets in the 7mmremmag.

 

[dumbdawg]

my A-bolt likes 175gr nosler partitions with 60gr of IMR 4831

 

[Rembo]

I load 69 grs of Rel22 under the 140 TSX for a bit over 3300

 

[Sask Hunter]

RL 22 worked VERY well, avg 3250 fps and my Ruger LSSS loved the 139 Interbond...but find a few manuals and have some fun...

 

[jacky]

I use 62 grains of IMR 4350 and a 140 grain bullet. It chrony's in my rifle at around 3100 fps, but work up your own load carefully. What works for some may not work for others and safety is always # 1.

 

[RojamB21]

H4831