7mm Super Mag

pmatuk

CGN frequent flyer
Super GunNutz
Rating - 100%
188   0   0
Location
DC Northern BC
I acquired a EABCO single shot falling block pistol in 7mm Super Mag .Have done a bit of a search for loading dies as it did not come with them and not too much luck yet .So made up 5 rounds with creativity and other dies I already have .Did fire form the 5 and they came out nice .

was thinking of cutting the neck .300 deep to be easier on the brass and form from 5.6x50R .

This creature is based of the 357 super mag/max brass .From my reading it has a slightly more case capacity than the 7mm TCU .
But the lil #### has nearly no neck and from measurements it could be loaded with the TCU dies ? but not sure as of yet .

any body have an old set of these odd ball dies laying around would be great (if they no longer have use for ) as they are semi wildcat and have to be custom ordered
siloetta 2.jpg
 

Attachments

  • siloetta 2.jpg
    siloetta 2.jpg
    147.1 KB · Views: 94
took it apart today and gave it a .250 neck .Used a 5.6x50R case to make the longer neck .Looked up the pistol on their web sight and they said they only use locking compound to hold the barrel instead of torquing ,and they were not kidding .Used heat gun and turned receiver from barrel by hand .Deepened neck reassembled and did a fire form .Now will have turn neck as the RWS is thicker
here is some pick of the results so far
011583B8-4CF4-4D9C-9ACE-7016A1DD5F7D.jpg
91C49E2A-F5AD-4067-AC40-BC972068EDC8_1_201_a.jpg
 

Attachments

  • 011583B8-4CF4-4D9C-9ACE-7016A1DD5F7D.jpg
    011583B8-4CF4-4D9C-9ACE-7016A1DD5F7D.jpg
    67.3 KB · Views: 49
  • 91C49E2A-F5AD-4067-AC40-BC972068EDC8_1_201_a.jpg
    91C49E2A-F5AD-4067-AC40-BC972068EDC8_1_201_a.jpg
    52.5 KB · Views: 48
Back
Top Bottom