9.3x57

[Win/64]

Anyone have any loads they would like to share?

 

[Noel]

In a 98 Mauser:
Metalverkin brass
CCI 250
270gr Speer SP, seated as long as the mag well will allow, 3.140 IIRC
H335 at 56gr will give you 2460fps.

Be ready to change out your front sight bead for one at least 1/32 to 1/16" higher because you will be hitting up to 8" high at 100 yards.
Trust me, it will........

This was nowhere near max in my rifle, it was just where I got to in a very short amount of time before I went on a trip last fall.
Groups averaged 1 1/4 at 100 yards. This was with once fired, neck sized cases too.

I tried H4895, IMR3031 and H414 I think but they didn't perform as well.

Hope this helps.
Noel

 

[Win/64]

Thanks Noel

 

[Johan22]

Check this link.

http://www.gunboards.com/forums/forum.asp?FORUM_ID=41

 

[iiijbird]

I use 51 grns of reloader 15
barns originals 250 grn
cci 200
metalverkin brass
loa 3.22
2340 fps with 24" barrel

good accurate load.

Curtis

 

[Noel]

Nice link Johan22! Those guys are not only hardcore 9,3 fans but alot of folks here could learn alot from the way they comunicate too! No bashing, why that is hard to get used to!
It seems quite suprising how their top loads in their rifles were way down from what I was able to achieve. Yet I had no case expansion with my load or flattened primers etc. They seem to be using mostly the 96 Mausers, perhaps that is why?

Guaranteed I will be spending some time reading over there!

Noel