9mm bullet mold without lube grooves - where to buy

[misterzr]

Looking at some of the ones from Accurate molds but want to see if I had other options, looking for a 9mm 125 gr with no lube grooves for powder coating, needs to be 4-6 cavity

 

[Spawn-Inc]

The closest NOE has is 135gr with a 5 cavity option as well as a 4 cavity hollow point /flat point mold.

 

[misterzr]

I looked on NOE and didn't see any without lube grooves

 

[tiriaq]

I am sure Accurate could cut cavities for you without grooves. All his moulds are CNC bored to order. Have you asked him?

 

[Spawn-Inc]

I looked on NOE and didn't see any without lube grooves

he lists the non lube groove molds in a separate section.
http://noebulletmolds.com/NV/index.php?cPath=84&osCsid=u55go09gqgd9d1sui0dnrq3vu1

 

[hometownhero]

he lists the non lube groove molds in a separate section.
http://noebulletmolds.com/NV/index.php?cPath=84&osCsid=u55go09gqgd9d1sui0dnrq3vu1

I have the 356-135 fn rg2. Very good mould. Recovered some of the hp beets and they look pretty darn good. I use a mix of 3 pure to 1 wheel weight and they come out at 130gr with the hp. I have had them at over 1200fps and no problems at all.

 

[quinnbrian]

Couldn't you throw a Lee mold in a lathe and remove the lube groves..just a cheap thought..setup would take sometime,but do-a-ble...
Cheers
Brian

 

[Bassmaster]

^^^^This....buy a cheap lee 2 banger and cut the lube grooves out.....a sharp knife and some time