9mm Round Nose MP Mold

I have it. It is a great mold for casting. No lube groove you just open it up and the bullets drop. Work great in my dlask 1911 and glock. However my buddies tanfoglio had to be seated lower.
 
I haven't used that mould, but MP moulds are very well made, but may cast a hair large.
If you use a hard alloy and have to size down three or four thou, it can be difficult.

I have bought throating reamers that open up the throat a whisker to allow proper seating.
Accurate Molds now makes a design that is slightly reduced in the throat area to allow for powder coating.
 
You must log in or register to reply here.
Back
Top Bottom