A few reloading supplies...

D

djmay71

CGN Ultra frequent flyer
EE Expired
Rating - 87.5%
7   1   0
Location
Eastern Ontario
I've been questioning whether or not to start reloading since I learned about it.
Now, it seems that I'm ready to bite the bullet and plunge in, however, even after reading a lot of information in this section, (plenty helpful- thanks!) I still have a few questions.
Also before we start, I'll be reloading .223, 5.56, .308, 9mm, and .40 S&W

1) I'm looking into the Horandy Lock N Load Kit. Seems to have everything I need- right? Well, minus the dies of course.

2) For mounting the press, I have a solution, since I do have limited space. I'm thinking of mounting the press to a 2x4 (or 2x6 / 2x8- whatever fits the best) and reloading in the garage using the bench mounted vise, and during the winter months, move the job inside and clamp the mounted press onto my desk. Viable?

3) Storage question: The only primers can be stored with you regular ammunition, correct? As for the powder- I have a storage solution. Store it in a small toolbox, and lock it up in my Mastercraft toolbox in the garage. Also- are there any regulations as to how big the 'Explosive' markings have to be? To satisfy the Explosive markings- could it just be written on, or is a sticker or magnet better?
 
Reloading .223 and 5.56? OK.....
For rifle ammunition, any single stage press and most any dies will produce decent ammunition. A best buy can be a good used press. Often seen at gunshows. Don't lose sleep over which brand. Handgun ammunition can be loaded on a single stage press. Given the amounts that can be consumed, a turret or progressive has advantages.
A press certainly can be mounted to a block or plate which is, in turn, clamped to a bench, desk Workmate or other work surface.
I would not store powder in a steel toolbox in a steel toolbox. In the event of a fire, this would hold pressure. Something that will prevent pressure buildup is a better idea. Don't overthink this. Signage? OK.....
Your first purchases should be a good manual or two. Read, mark, learn and inwardly digest.

Do you know anyone who is an experienced reloader?
 
Have a look at Budget Shooter Supply at the top of the page. I got my LNL from him with all the goodies. Great press and I can turn out 300 an hour without breaking a sweat. Pretty sure he has the kit that comes with a Hornady manual as well, at least he did cause thats what I got. Get yourself a nice little digital scale and have at 'er. Welcome to the club ;)
 
What Tiriag said X2

Also - progressives are good for producing lots of ammo in a hurry - so maybe for pistol shooting or 223 etc, cheaper than factory but not necessarily super accurate.

If you want all the bullets to go through the same hole then a single stage for your .308 would be better. You can do .308 on a progressive but dont look for super accuracy (again, my opinion only, not asking for agreement by the masses)
 
djmay71 said:
Anybody know where just a manual can be purchased? Preferrably site sponsor?
Click to expand...

All of the powder mfrs have reloading data on their web sites. I suggest you buy the book ABC's of reloading, and after reading that buy one of the books by the mfr you are looking to use before you start reloading.

Personally I buy books from a few different ones as I do change the bullets and powder and prefer to have the oem data to compare with others.
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom