So I have a removeable carry handle sight that will take an A1 style rear site.
Thanks Guys!
Then after much 'oohing and ahhing' by Canada Border Service Agents, I have the bits for my rear site assemblies.
Now I need some help figuring how to assemble the rear sight bits into the carry handle.
So if anyone has a good link to a diagram or pictures showing how the bits all go together, that would make me a happy gun nut.
I recognize some of the bits, but I have this nasty habit of sending the odd springs and dowels flying about the work area.
The screw, that makes sense, goes in from the left.
The flip sight, easy to recognize, same with the flat plate spring, but does it go round belly up or down.
The dial on the right, I know.
The plunger to spin the dial I understand.
Now I have a tiny spring, an extremely small dowel (under the dowel plunger like the take down pin dowel and spring?) and a dowel I suspect goes through the dial when it is all together?
Needless to say, help will be appreciated.
Cheers
Lawn Gnome
Thanks Guys! Then after much 'oohing and ahhing' by Canada Border Service Agents, I have the bits for my rear site assemblies.
Now I need some help figuring how to assemble the rear sight bits into the carry handle.
So if anyone has a good link to a diagram or pictures showing how the bits all go together, that would make me a happy gun nut.
I recognize some of the bits, but I have this nasty habit of sending the odd springs and dowels flying about the work area.
The screw, that makes sense, goes in from the left.
The flip sight, easy to recognize, same with the flat plate spring, but does it go round belly up or down.
The dial on the right, I know.
The plunger to spin the dial I understand.
Now I have a tiny spring, an extremely small dowel (under the dowel plunger like the take down pin dowel and spring?) and a dowel I suspect goes through the dial when it is all together?
Needless to say, help will be appreciated.
Cheers
Lawn Gnome
