accu trigger going under the knife

[titch--]

I couldnt pass on a super cheap ss axis in 204 from a friend, so its getting set up for coyotes this winter.

Had a accutrigger laying around that I threw in it and on load development I noticed that it had some creep to it, so I was wondering if anyone has added a sear adjustment screw to an accu trigger before? Im going to go out and buy a set screw for it this week and put in under the knife.

Just wondering if anyone had done this before and if there anything special I had to do for it, or if this is a all around bad decision.

 

[kamlooky]

Photos and a detailed report on this surgery...........

 

[Gunneegoogoo]

Have a steady hand, a solid vice, and a good camera to document it for us!!! Ballsy move, but I don't see why it wouldn't work with the right plan. If it's an extra trigger, I guess even if you botch it, you're OK.

-J.

 

[dero338]

if your surgery fails, a riflebasix SAV1 will fix it.

 

[titch--]

A buddy has one of those vices for a drill press that Im going to use. Im sure that should get the job done.

Ive installed a couple sav1"s now in some 200's and thats kind of where I got my idea from. I also cant see any reason why it wouldnt work.

Just uploaded a few pics so I thought I would add some colour to the thread. Just a shot when I was doing my initial load development. Its also got some new glass since that pic