Adjusting an XMark trigger-DIY?

Rugerman

CGN Ultra frequent flyer
Rating - 100%
156   0   0
Excuse me if this has been discussed already. Couldn't find anything here. I have a Remington 700 SPS. It has the XMark trigger. I am not happy with the pull weight. I can't even get a reading on my gauge. It is over 4 pounds. The manual says to take it to a gunsmith to adjust the pull. Is this something that can be done by someone with some basic smithing skills or is it better left to a gunsmith?

If it can be done, does anyone have any instructions on how to do it?

Thanks.
 
not true :) you can heat the screw this the solder and as soon as it starts smoking - unscrew is , clean with solvent and proceed according to the link provided above :))))
 
Back
Top Bottom