Adjusting Remington's new trigger

[chuck nelson]

Has anyone adjusted the new X Mark Pro trigger?

 

[Jim AB]

One of the guys off 24hr Campfire has a little blurb on it. I'll see if I can track it down.

Jim

 

[Jim AB]

http://www.24hourcampfire.com/ubbthreads/ubbthreads.php/ubb/showflat/Number/2596879/page/0/fpart/1

Try this Chuck.

 

[Crazi]

There is a sealer over the "screw" heads that needs to be scraped off, then you can use a 1/16" Allen key to adjust them. The lower front screw is your weight, top front is over travel, and rear is sear. From my experience, the pull weight screw is the only one that doesn't feel locked in.

 

[chuck nelson]

Thanks Jim

 

[chuck nelson]

and Crazi

 

[Duck_Hunter]

Good luck "scraping" the sealant off, you need heat! I tryed scraping, acetone, and a soldering iron. The torch did the trick.

 

[chuck nelson]

Thanks gentlemen. Mission accomplished.

 

[Fixit]

my sealant flaked off when i looked at it... nearly no adhesion.

when i reduced the pull too much, it wouldnt ####. turned it back a bit and all is well.

there are a few safety checks to do after too.

 

[horseman2]

I took the 24campfire posting and compiled it on a Microsoft word document complete with pictures. Anyone wanting it can send their e-mail.