Advice Sling mount sulun tac12

[HvacFridge Apprentice]

Just wondering how guys are mounting a sling to their sulun/canuck or benelli m4’s.
I saw a front sling loop attachment from S&J hardware (pic rail on one side for light). But that’s all I’ve been able to see so far.
What are my options?

 

[ric0shay]

I have a 2 point adjustable sling (made by me) attached on the left hand side at the front and the right side at the rear with the quick disconnect. I put a mag tub mounted pic rail for a standard light (stream light w/2x AA batteries and a tail switch).
I'd show a picture but I can't yet. Hey I was wondering, does your magazine cap ratchet and lock in place? Mine didn't but I machined some material away and it works as it should now. The feed ramp was a little rough so I carefully worked at it too.
If you are thinking about an S&J Hardware bolt release bar they need a little material removed from the fore stock to allow room for the tab on the bar.
I've taken mine apart, addressed certain items like the cocking handle, bolt release latch (inside polished mating surfaces). and fire a few hundred rounds of Challenger 71/2 with a few failure to ejects early on. It's due for another tear down and cleaning/lube. It is a new project for me so I have been all over it recently. If you run into something maybe I can help.

 

[HvacFridge Apprentice]

Ah thanks for the heads up on that man!
I haven’t gotten a good look at my tac12 yet because I’m out of town for work, it’s home waiting. I’ll get back to ya once I’m home and can check that cap.
I just realized there’s a QD slot on the buttstock, my bad.
I assume there’s a loop to thread a sling through on the mag tube eh? If not I’ll go with the S&J sling/light mount

 

[ric0shay]

Yes, there is a sling attachment plate with a 1.125" (26mm) slot for a sling. An external snap ring holds it in place. That S&J mount would be pretty slick, I was thinking of one of those too.
I just upgraded my membership so I'll be able to add picture soon, there worth a thousand words I'm told.





S&Jhardware Bolt release

 

[HvacFridge Apprentice]

That’s exactly what I needed to see. Thank you very much man!
I had a total brain fart, not realizing this thing had a QD on the stock, and a 26mm ring on the mag tube, my bad. I’m away from home for work and the sulun is sitting in the shopping box at home

 

[ric0shay]

I have taken mine out again, easily 250 rounds and 1 failure to eject at about round 25. Nice piece of kit, I'm enjoying mine more every time I use it.

Oh, my choke needs to be checked and tightened every so often so it doesn't launch itself down range. Hopefully yours stays tight!