Annealing And Neck sizing

[Lead hammer]

What kind of die? Full Lenght?

I'll be using the LEE neck sizing die so so not sure it could gall up as it kinda squishes the next back to spec as opposed to using an expender ball?

I'd like to deprime > tumble > anneal > neck size (& body size intermittently - as required when the bolt gets too tight)

I also use the body die every time. I don't want the bolt to ever get tight, might be at the worst possible time, plus the consistency of each load will get better.
Also use the nylon brush and graphite inside the case necks before charging. Makes a big difference.

 

[Sniffer]

I also use the body die every time. I don't want the bolt to ever get tight, might be at the worst possible time, plus the consistency of each load will get better.
Also use the nylon brush and graphite inside the case necks before charging. Makes a big difference.

You know after reading up I'm leading towards body sizing every time now too.

I guess I could make a batch of each and see which performs best.