Any Canadian store selling reduced AR trigger spring kit?

lavino said:
The only place I found in US that will ship is Brownells. Anyone know any Canadian store selling these? Would prefer to buy from Canadian for this one.
Click to expand...

CRAFM usually has the JP kit. That's where I bought mine.
They're a site sponsor.
Good luck searching their site though.
Maybe an email or call will be better.
 
Anyone else? I'm looking for the JP CMP springs, probably just order through Brownells, but if there's a sponsor. I tried calling CRAFM after trying the webpage, no answer...As a rule if I call and you don't pick up the phone during business hours, no soup for you.
 
The JP spring kit works great and yes good luck searching and sifting through CRAFM's website, it is terrible! Don't expect much if you are putting it in a Norinco CQA though, those triggers are machined on the rough side.

https://ctcsupplies.ca/ carries some JP Enterprise parts but the spring kit isn't shown online.

http://www.armseast.com/store/ might have some to but not shown online.

I know you are just looking at spring kits but I suggest this trigger/spring kit http://www.armseast.com/store/alg_defense_triggers/alg_combat_trigger_act_/
 
redshooter said:
Anyone else? I'm looking for the JP CMP springs, probably just order through Brownells, but if there's a sponsor. I tried calling CRAFM after trying the webpage, no answer...As a rule if I call and you don't pick up the phone during business hours, no soup for you.
Click to expand...

Montreal just had a record snowfall overnight and it's still snowing now.
We had what was reported as 40cm but the front of my house had over 70cm.
300 motorists were stranded on highway 13 overnight.
I told my employees to stay home today.
I doubt that they opened today.
 
thump_rrr said:
Montreal just had a record snowfall overnight and it's still snowing now.
We had what was reported as 40cm but the front of my house had over 70cm.
300 motorists were stranded on highway 13 overnight.
I told my employees to stay home today.
I doubt that they opened today.
Click to expand...

Now that's a pretty good excuse...I guess I can try again tomorrow.
 
MET said:
I know you are just looking at spring kits but I suggest this trigger/spring kit http://www.armseast.com/store/alg_defense_triggers/alg_combat_trigger_act_/
Click to expand...

Actually I think you have a very good point. This is not for a Norinco ;) I am trying to mod the trigger pull on my JR Carbine. I originally got the Trigger Tech trigger for it (really awesome!!!) but it gives random 'won't reset' issues unless the load is really hot (blow back.. sigh... CCI factory turns into bolt action). Funny is that it will load the next round but won't reset. Since the default trigger has no problem at all I decided to try reducing the trigger pull using the original trigger and see what happens. As long as I don't have light primer strike it should be fine using factory trigger with slightly reduced trigger spring. May be I will give the ALG trigger some thinking... The factory trigger is actually not horrible to be honest I got a special grip screw to reduce the pre-travel but the reset is really bad on the factory trigger.

The Trigger Tech will go into the AR in future for sure. I wish it would just work flawlessly in the JRC....
 
Last edited:
Thanks for the tip thump-rrr. They didn't have the CMP springs, but they did have the 3.5 lbs. set. I'll give those a try, if they work great, if not I'm out a fraction of what a trigger will cost...and I'll have a set of springs for the JP trigger I'll order.
 
You must log in or register to reply here.
Back
Top Bottom