Anyone carry a Keymod or free float for an AR10?
- Thread starter mtlgunnut
- Start date
Find a retailer that sells Apex machining products. I have the gatorgrip and it's awesome.
I'd tell you where to look but my rifle came this way.
View attachment 16891
I'd tell you where to look but my rifle came this way.
View attachment 16891
Last edited:
Last edited:
i give up no one has anything.. its all from the us and 4-6 week wait
Welcome to Canada. Not much support here.
The AR-10 platform is not popular enough here for retailers to stock much for parts. Order and wait is the name of the game here.
Call Tier One Armoury in Edmonton
780-473-4043
sales@tieronearmoury.ca
They will help you out.
is that going to work ??
This is what i got from Windham Directly...
Our .308 has AR10 rail height and DPMS spec barrel nuts. The bbl nut thread is 1 7/16” – 16UN. The thickness behind the charging handle is about .240”
Unless you have one of the DPMS LR-308's with the raised rail the KAC forend should work. I was looking on Apex site at compatibility of each model and the DPMS and KAC use the same forend.
http://www.apexhandguard.com/2360-a...-7-oz-with-hardware-apex-gatorgrip-handguard/
Compatible with: S&W M&P10, DPMS, & Knights Armament SR-25
August 2009 changed the height of the top rail on the LR308 upper receiver. To properly match your receiver height, measure the distance from the barrel's centerline to the top of the receiver rail.
PRE August 2009 model is 1.313"
POST August 2009 model is 1.253"
Do you have a Windham AR-10? The above stuff only applies to a DPMS as far as I know. If your's uses a DPMS pattern barrel nut then the KA forend should work.
Compatible with: S&W M&P10, DPMS, & Knights Armament SR-25
August 2009 changed the height of the top rail on the LR308 upper receiver. To properly match your receiver height, measure the distance from the barrel's centerline to the top of the receiver rail.
PRE August 2009 model is 1.313"
POST August 2009 model is 1.253"
Do you have a Windham AR-10? The above stuff only applies to a DPMS as far as I know. If your's uses a DPMS pattern barrel nut then the KA forend should work.
