Anyone tried dominion powders 9.3x62

[ginsingjones]

curious as to if anyone has tried any of the D powders in their 9.3x62.

 

[ginsingjones]

Bump

 

[Buckmastr]

I haven't tried them in a 9.3x62 but the D4064SC has loaded the same as IMR 4064 in my loads so you should have no issue.

 

[ginsingjones]

Ok thanks
Ya i havnt purchased any of that powder yet. I think I might have to try it.
I was holding out for d4198 before my next order but if they arnt expecting any till next year I might have to order

 

[todbartell]

I'd go 8208 in the 9.3

 

[pacobillie]

Ok thanks
Ya i havnt purchased any of that powder yet. I think I might have to try it.
I was holding out for d4198 before my next order but if they arnt expecting any till next year I might have to order

Any of the 4198s will likely be too fast a powder for that application.

 

[ginsingjones]

I am aware 4198 is too fast. I was waiting for that powder to do a big order not to use it in my 9.3
Wouldn't 8208 be a little on the fast side as well.
My go to powders have been varget and big game

 

[periculumnexnecis]

I use dominion 4895 in 9.3x57, 286 grain lead with great success

 

[Potashminer]

....
My go to powders have been varget and big game

For 9.3x62, that is exactly what I have been using - Varget with 250 Accubond, and Big Game with 286 Partitions. Out here, at least, have not seen any to buy in a while - will be "running on fumes" if I am not careful!!!!

 

[mbogo3]

Re#15