anyone uses Herco powder?

IM_Lugger

CGN Ultra frequent flyer
Rating - 100%
216   0   0
Location
Hamilton
I'm thinking of using Herco powder for 9mm. I've only used Blue dot and Power pistol Alliant powders, how does Herco compares to the two?

Is it clean burning? consistent charge?
 
I bought a few pounds on sale a few years ago. When reloading .45ACP I was surprized by the rather high velocities I was achieving (900FPS plus). If you have a supply of it, it's not a bad powder. As I recal, the flash was nothing big. Herco burns a bit cooler then other powders but not as clean as others. Good load density, but it's a flake powder, so it may not measure well in a Lee dispenser. I've not had any problems with my RCBS dispenser.
 
Last edited:
it's a flake powder, so it may not measure well in a Lee dispenser
hmm...I've had problems with blue dot; with an Auto Disk instead of 8gr I was supposed to get I was getting 7.5 at most :eek: I remember Power pistol was right on the money (don't remember if it's a flake powder)...

anyone tried Herco in Lee Auto disk?
 
Last edited:
IM_Lugger said:
hmm...I've had problems with blue dot; with an Auto Disk instead of 8gr I was supposed to get I was getting 7.5 at most :eek: I remember Power pistol was right on the money (don't remember if it's a flake powder)...

anyone tried Herco in Lee Auto disk?

I use unquie and titegroup with auto disks and they are both short of the specified amounts by about .3-4 grs However the MV seems to be quite close to the book and the gun works fine, so I am not worried.
 
Back
Top Bottom