AR-15 with magpul CRT stock, cheek riser question

micromind

micromind

CGN Regular
Rating - 100%
100   0   0
Location
Oil Country
So I have a Magpul CRT stock and need a cheek riser due to high optics. Looking at the web site the cheek riser that magpul sells as a clip on, but says it will interfere with the AR charging handle, any suggestions on what to use?
 
I feel like the obvious answer would be to use a lower optic mount. Most anything AR specific should be the right height and not require a cheek riser. What are you using?
 
I’m using a bushnell ar scope and needed a high mount to make it just fit, when shooting I feel like I’m compinasating for the height. I need my eye just up a bit otherwise I feel like I’m looking through a para scope
 
micromind said:
Out all the way, that’s what I wanted to know thanks
Click to expand...

I just verified this with my CTR stock and riser from another rifle. With a 6 position buffer tube and the stock extended all the way out there is JUST enough clearance to lock the bolt back. This was using an AXTS Raptor charging handle. Your mileage may vary depending on your particular set-up. Hope that helps.
 
You can look into the Larue RISR mount part of the cheek rest slides back when you pull the charging handle and then the cheek reset resets into the forward position. It's designed for Magpul stocks and there's a plate that slides inside the stock where those two slots are on each side of the stock and then the RISR screws into that plate.

Rampart has them in stock https://rampartcorp.com/products/la...cating-inline-stock-riser?variant=21983798535
 
thanks all for the reply's, went with the magpul one. it does not effect anything as long as the stock is all the way back. and that's how I use it anyway.
 
You must log in or register to reply here.
Back
Top Bottom