AR15 Dimensions Needed!

[MXoutdoors]

Hey Guys,
I'm in the middle of designing a stock for my Tikka T3, and I want to use an Ar15 type pistol grip, but I can't find all the dimensions I need to do so.
I dont have a lower reciver or do I know anyone that dose, so I was looking for so help.
I need four dimensions, in the photo below I have labled the dimensions I need. I need a radius for "W" and "Z" and a thickness of the main body (X) and also the hiegth of the radius (Y)
On another print I have their was a Ref # of 1.390" so I'm thicking that "Z" might be around .780" and "W" .390"r

Thanks for any help Guys,

Ron

 

[Armedsask]

Wish I'd seen this sooner. I'll get you the dimensions tomorrow if someone else doesn't beat me too it.

 

[Armedsask]

Bump. Dimensions are as follows:

W: 0.430"
X: 0.906"
Y: 0.561"
Z: R0.75"

Your reference dimension shows as 1.384" on my solid model. So I'd go with 1.39". I make no guarantees to the accuracy of these dimensions. All dimensions taken from a solid model of unknown origin.

 

[MXoutdoors]

Thanks for those dimension armedsask, They seem about right, the X seems a little big, I would of though it would be more around .865, that it the thickness at the top of the A2 grip I have, witch makes the W size about right.
That should be what I need to keep going, thanks again.