Arms 18

[hfp75]

Lookin for some info. I am going to be putting an ARMS 18 on one of my rifles and dont have the ARMS info sheet. I can easily figure out how it goes on but am wondering if anyone knows of an online manual/set of instructions for me to reference. I am also wondering if I should use Loctite Blue or Red - I am guessing Blue.

H

 

[LeftFootOfDoom]

be aware that you MAY experience problems with the odd spent casing not being ejected due to the low level of the arms rail. If so, you may have to trim your extractor & ejector spring by 2 coils.

one thing you might want to do is to replace the small allen set screw on the front of the rail with a straight allen key screw with no head. Otherwise you'll have to file down a bit on the handguard.

 

[Sosa]

Just bolt it on. I haven't even needed locktight on mine but I would recomend blue if you want. I didn't change the front bolt but it did scrape up the chu wood a little bit, oh well. If you've got a good stock change it out. The only problem I had was once I had my scope on I ran out of elevation and had to adjust the front and rear screw holes to get a better angle.
Good Luck