ARMS #5 mount

[rhs]

Hi,

Just got back from the range after installing an ARMS #5 mount to raise my scope off the gun. Also installed one of the Tubbs recoil springs. Group size has more than doubled. The ARMS instructions says that you are only supposed to tighten finger-tight. Do these things hold zero without torquing them down, or should I be looking at a different riser ? Am going to go back to the factory recoil spring in any case, since the gun started having trouble stripping the first round off the mag.

Thanks,
Ron

 

[KevinB]

ARMS = WHY

#### Swan and co. used to be very inovative - recently his stuff has sucked - and both the design and manufacture of ARMS products has been sub-par.

Nothing will hold a zero without being torqued to a point.