About 5 and a bit years ago I completely disassembled my rifle to the bare receiver. At the time, I never thought to document the process. I would like to put this jig saw puzzle back together and I'd like to do it right the first time. Found a few videos on ar10 assembly and I know that will get me close, but I know there are differences however slight. I have time, tools and patience and want to make this rifle whole again. Any help would be appreciated.
BCL 102 reassembly
- Thread starter weasel1
- Start date
I don't know, that's why I am asking the question before I proceed. I believe the mag release is different, the safety selector should be the same. It's the subtle stuff I don't want to miss.
The assembly is virtually the same as a AR15 with just slightly larger parts.
I remember getting the handguards to line up with the barrel nuts was a complete nightmare when I was assembling these rifles (Version 2) years ago for the shop I worked at.
Hopefully your exact rifle is one of the ones that did manage to run flawlessly.
I remember getting the handguards to line up with the barrel nuts was a complete nightmare when I was assembling these rifles (Version 2) years ago for the shop I worked at.
Hopefully your exact rifle is one of the ones that did manage to run flawlessly.
It was one of the good ones, hence my apprehension to put it back together. If I get this right it will be as good as I remember.
Yes. Completely stripped. Not one of my proudest moments.
