Beartooth Comb Raising Kit?

It works for me. I got one for my Lee Enfield No.4 because I like to use the Cad-Technik scope mount, which puts the scope high, and I didn't want to make any permanent change to the wood, e.g. screwing on a No.4T replica cheekpiece. (I did use a replica T cheekpiece on another No.4, and that works great, I just didn't especially want to do it to this rifle, and the Beartooth kit was easier to get.)

And then I wanted to use sight-through rings on my Savage 24F combination, so that scope is rather high, too. There were enough pads left over from my original Beartooth kit that I only had to get a Beartooth buttstock shellcarrier for the Savage and use them with that.
 
Last edited:
comb

We ordered one for my wife's CIL(savage) bolt 30-30 with a sidemount(offset) scope. They didn't have the beartooth kit, so we got a different brand without the different slip-ins.
Took a little to get it laced on in "just the right spot", but not that much.
It works great, and doesn't move or anything.
 
I bought a Scope EZE from Brownells. For
my Savage 111F because the Medium rings left my check off
the stock.

Takes a bit of measuring to figure out which one you need.

There are two types: stick on and strap-on... (tee hee...)

The strap on doesn't move after firing. I recommend it.
 
Last edited:
I've bought several, and used the foam inserts left over with other slip on sleeves on other guns. They are a truly great idea for both shotties and rifles.
 
You must log in or register to reply here.
Back
Top Bottom