Bedded the CZ Scout
- Thread starter Clayne_b
- Start date
That poor little kritter.
Ya dun everything but circumsized the poor beast.
Looks like you were a tad short of bedding fluid, but
not horrible to say the least.
Post some targets.
You know, those thousand yard ones............
Ya dun everything but circumsized the poor beast.
Looks like you were a tad short of bedding fluid, but
not horrible to say the least.
Post some targets.
You know, those thousand yard ones............
Looks like it should work. I bedded mine too, but only the front and rear voids. Setup this way i can run a buisness card along each side of the action between the stock.
Turned out well and shrunk groups a bit, but more importantly eliminated the flyers I was getting. Let us know how yours works out. These scouts are really neat little guns!
I'm sure enjoying mine, In part thanks to you Clayne... Following your threads led me down this path. I even added the same bipod recently, does it ever improve the usefullness of this gun. I find it even makes it balance like a full size rimfire rifle. I also put a pachmayr pad on to extend the stock a little over an inch.
I love the optics set up too, the vortex scope matches the rings and receiver like they were made for each other.
Turned out well and shrunk groups a bit, but more importantly eliminated the flyers I was getting. Let us know how yours works out. These scouts are really neat little guns!
I'm sure enjoying mine, In part thanks to you Clayne... Following your threads led me down this path. I even added the same bipod recently, does it ever improve the usefullness of this gun. I find it even makes it balance like a full size rimfire rifle. I also put a pachmayr pad on to extend the stock a little over an inch.
I love the optics set up too, the vortex scope matches the rings and receiver like they were made for each other.
Last edited:
