Benelli M4 Jumbo Bolt Release Timeframe....
- Thread starter spellbound
- Start date
- Location
- East ontario
prob not till april
we only have 1 cnc lathe and we have been running non stop 6 days a week magazine tubes since November, we have 3 other styles of mag tubes and a small run of m14 match grade spring guides and a few hundered linear comps to do then we be doing more m4 charging handles and the m4 jumbo safety button.
this is the plan for the next 4 to 6 weeks
we are going to try very hard to stick to this as far as CNC lathe work go,s.
As for a new complete bolt release that is in the work for no eta as of yet we were going to make an over sided pad that you could dril land tap onto the one this is factory , but did not get great feed back on that idea.
simon
we only have 1 cnc lathe and we have been running non stop 6 days a week magazine tubes since November, we have 3 other styles of mag tubes and a small run of m14 match grade spring guides and a few hundered linear comps to do then we be doing more m4 charging handles and the m4 jumbo safety button.
this is the plan for the next 4 to 6 weeks
we are going to try very hard to stick to this as far as CNC lathe work go,s.
As for a new complete bolt release that is in the work for no eta as of yet we were going to make an over sided pad that you could dril land tap onto the one this is factory , but did not get great feed back on that idea.
simon
