Benjamin Marauder .22 Generation 2 Question

lanshoka

lanshoka

CGN Regular
Rating - 100%
127   0   0
Hello..

Does anyone here know how to adjust the Marauder from the factory default 2500-2600 psi maximum fill setting to 3000 psi? I've checked the manual and online but I can't find an answer.

I use a freshly filled scuba tank to recharge the air cylinder and not a hand pump. Not sure if that makes any difference though.

Any help you can provide is appreciated.

Thank-you.
Jim.
 
Factory is 3000PSI. Are you going by the gauge on the gun? They're rarely accurate. Everybody I talk to, their Mrods are few hundred PSI off. My Benjamin Maximus guage was off too,
 
OkayShooter said:
Factory is 3000PSI. Are you going by the gauge on the gun? They're rarely accurate. Everybody I talk to, their Mrods are few hundred PSI off. My Benjamin Maximus guage was off too,
Click to expand...

The gauge reading on the air tank matches the Marauder gauge reading when I refill the gun reservoir. I've read online that the factory setting is 2600 psi. I've also read that the Marauder gauge can be off by quite a bit as you've mentioned.
 
You must log in or register to reply here.
Back
Top Bottom