Beretta 686 ejector timing needs adjusted??????

300wmxcr2

300wmxcr2

CGN Regular
Rating - 100%
75   0   0
Location
Ontario
Got a Beretta 686 Sport with around 1000 rounds, the last half dozen rounds of trap it wasn’t ejecting properly. I have watched a few YouTube videos and it seems like the ejector timing needs to be adjusted. Seems like a fairly simple adjustment with a file but can’t really find a good how to video.
Who is a good gunsmith in northern Ontario who has experience one these or do I need to send it in to Stoeger Canada?????
 
What Ashcroft said is great advice.My Beretta Gold ASE had timing issues on both sets of barrels,apart cleaned lubed no more issue.Thinking there was some fines in there that had to be worked out.
 
Ashcroft said:
Before doing anything drastic, try carefully removing the ejectors, clean them and their operating recesses thoroughly, lube, reasssemble.
Click to expand...

Thanks. Tried exactly that, removed ejectors, cleaned both ejector and ejector slots, reassembled with a small amount of gun grease and still the same. Timing has always been off a tiny bit from upper to lower barrel. The lower was the late one but it was really wasnt an issue until the last few rounds.
 
I believe there is a video on youtube that shows someone filing the ejectors you might be referring to that already ,if you care to try yourself..
 
Yes seen this very good video but its very hard to see exactly where the material is being taken off. Don't want to start filing BEFORE knowing what I'm doing. Far from a gunsmith but have fixed/ adjusted more that a few guns. Figuring out after the fact what you should have done sometimes can get expensive.
 
You must log in or register to reply here.
Back
Top Bottom