Bipod adapter wont fit my norinco m14

jcpal

jcpal

CGN Regular
Rating - 100%
4   0   0
i got a harris bipod adapter from fabsports and it says for m14 but it does not fit my norinco what to do any help would be great thanks
 
I have a harris that I first installed on the M14 after removing the front sling swivel and JBWelding the mount into the GI stock.

HAR-HB2R.jpg


Once I got one of M14Doctors stocks, I used a weaver mount.
 
Try to get a hockey helmet repair kit. Then take the silver part and slip it into the gas whole. Then screw the harris bipod directley to it.
I will post pic's tomorrow if I get a chance. As I have done this and it's working out just great ;)
 
on my norinco plastic stock there is a hole in front of the sling swivel but the base of the adapter is to long it hits the i guess you could call them colums of the inside of the stock
 
jcpal said:
on my norinco plastic stock there is a hole in front of the sling swivel but the base of the adapter is to long it hits the i guess you could call them colums of the inside of the stock
Click to expand...

I have same adaptor on my norinco, I drilled a hole befoe the swivel to fit it just make sure you leave enough space so that the Harris doesnt touch the swivel
 
Hockey Helment Repair Kit To Hold A Harris Style Bi-Pod

Crude but works very good. Although you do loose your vent whole on your stock but no major mods are required to your stock.

IMG00156-20110219-1325.jpg

IMG00155-20110219-1237.jpg

You can also use the QD stud and the back end of the Helment repair kit too!
;)
 
You must log in or register to reply here.
Back
Top Bottom