Blacking out a Ruger 454 revolver
- Thread starter Backwoods
- Start date
mmcintyre1220
CGN frequent flyer
- Location
- Tillsonburg, Ontario
Checkout CDN Gunworx. They do a bunch of non Cerakote finishes
Be careful using them as per previous threads I have read..
They take forever and people have gotten firearms back with mismatched or improper parts that have been swapped out either by accident or intentionally I was personally thinking of using them myself until I read all the complaints etc so the project is on hold.
They take forever and people have gotten firearms back with mismatched or improper parts that have been swapped out either by accident or intentionally I was personally thinking of using them myself until I read all the complaints etc so the project is on hold.
For sure. I don't think mismatched parts or other parts would be an issue with a one off revolver, but if it looks to sketchy I'll just have to cancel the idea. In hindsight I maybe should have had one done in the US and then imported it, but what can you do.
mmcintyre1220
CGN frequent flyer
- Location
- Tillsonburg, Ontario
Hmm I haven't had any work done by them but i have not found any complaints about them either
Good to know Thank You for this, sounds shady
