Browning bar issues

[Crouchy]

I have a 1980 Browning bar in 7mmremmag. It will not cycle the next round in. I get everything from failure to eject to stove pipes. I have followed everything as far as tear down and cleaning goes by this video.

www.youtube.com/watch?v=afvhm_Gvhew

It still doesn't cycle. I have ran it dry and wet in the action.. All testing was done between 10 and 18 deg Celsius. Only Thing I can think is to replace the spring? but want to know if there is anyother profound ideas out there first.

Thanks for your time.

 

[7.62Nato]

Most likely a tired action spring.Had one in 30-06 that did the same thing after 1k rounds. Changed out and good to go. Change the buffer while your at it. WGP has all the parts.Action spring was weak and moving too fast.

 

[Dosing]

Spring, buffer, check the chamber for any damage, check the rails, and gas system.

 

[nowarningshot]

My first thought, because I've done it, you put the piston in wrong.