Browning Blr Trigger Disassembly

[fk95]

Hey, Hope everyone is doing well. I was wondering if anyone has experience taking apart the Browning Blr Takedown trigger assembly. I am pretty mechanically inclined and have taken apart and put together my BLR on multiple occasion with no issues, but have never gotten into the trigger assembly. After a few years of use I'm starting to see little spots of rust and wear here and there so I'm thinking of just getting it cerakoted black just for a little extra protection but for the trigger to get properly coated, it seems I need to disassemble the trigger assembly. Any advice or knowledge would be greatly appreciated and while I'm at it, if anyone has any experience performing a trigger job on these beauties, I would appreciate your knowledge and know how on that as well. I love my Takedown Blr especially, and since its almost impossible to find one nowadays since they've been discontinued, I want this one to last me as long as possible. Anyways, I just wanna say thank you for any and all advice, and I wish everyone a happy new years.

 

[Patriot762x51]

 

[Lodi]

Reassembly requires timing, this is where most people have issues. You must have the patience to try and try again until it's correct. Read all you can on the subject then decide if you want to tackle the job.