Buffer tube help,for Cadex chassis

[Brianma65]

Hey guys, I just ordered a Cadex chassis and want to put a CTR stock on there.
Problem is ,when My gunsmith received the buffer tube and stock,there were no lock nut,jam nut, or locking washer,with it.
Do anybody know where I might be able to get these items?

Thanks.

 

[jadam]

You'look need a castle nut to lock the buffer tube in place. A few of the vendors that carry small parts should have them on hand. If you have no luck tracking one down, PM me and I have a used one I can spare for the cost of shipping.

You may also need an end plate, I'm not familiar enough with the Cadex product to know.

Good luck!

 

[Brianma65]

You'look need a castle nut to lock the buffer tube in place. A few of the vendors that carry small parts should have them on hand. If you have no luck tracking one down, PM me and I have a used one I can spare for the cost of shipping.

You may also need an end plate, I'm not familiar enough with the Cadex product to know.

Good luck!

Thanks, I've found the castle nut ,online ,not sure if I need a endplate though. Thanks

 

[Rickster66]

you may have an an A2 tube on the chassis. Mine did. It does not use a lock nut. Do you have an A2 or Carbine Stock? The a2 length stock has the mating piece that fits into the lower receiver to keep the stock from spinning.

another view

If you have the regular carbine then you'll need the other bits.

 

[Brianma65]

I'm using a CTR stock. (Colapsable)