bullet puller on a press

D

David L

Regular
Rating - 100%
227   0   0
Do you know sort of a piece that you put over a reloading press to remove bullet. It's instead of hammer cause my cartrigde don't fit .
My press is a Redding ultramag , and the caliber is 338 lapua
Thanks
 
You can't go wrong with any of them, I use the RCBS model and it works good for me on both cast and j-word bullets, much faster and less messy then the kind you pound the sh-- out of.
 
Another vote for RCBS. Mine works on .338LM, 45 ACP 230gr RN + 185gr JSWC, and 9mm 127gr RN. Bullets come out unmarked, slick as a whistle, great tool! Put a Hornady L&L conversion bushing in my Redding Ultramag and use the L&L bushings with dies and the bullet puller as well. Sure makes life easy when dies/tools virtually drop in and pull out of the press fully adjusted.
 
Ganderite said:
Pair of pliers works if you only have a few...
Click to expand...

X2 for me. If they are really stuck I latch onto them with vice grips and pull them out using the press. Of course, the bullets are only good for shooting around corners after that :D. Come to think of it they don't look so good after using pliers either. Have to admit the kinetic hammer always scared me a bit. It just seemed wrong to slam a loaded bullet somehow. The RCBS collete style puller has worked well for me over the years as others here have found, but I still have had to use the vice grips from time to time. Haven't found anything they wont grab.
 
You must log in or register to reply here.
Back
Top Bottom