bushnell barner 6.5x24x40 mil-dot issue

sigp226

sigp226

Regular
Rating - 100%
23   0   0
Location
québec
I got this scope and i am not able to zero it so decide to order a bore sighter and see what's going on with it. install bore sighter on and begin to play with the knob, first complete turn of the knob the cross air stay at the same place on the second turn they begin to move?


so my question is
do you think it is scrap or it is normal and this is a piece of crap?

thanks for your help sigp226
 
Last edited:
the scope is very good for the price, I have one. Problems with it, just take it to bushnell in toronto and they will replace it no question asked.
 
i were trying to reach the zero but were aroud 1 feet off in elevation. but what i could observe the cross air did'nt move until one full turn of the knob what i think it's not normal. i think that's what cause me the issue.

I will try send it back to bushnell and see what they will answer.

thanks
sigp226
 
sigp226, sometimes those scopes dont have alot of movement like moa and when they get towards the top of their adjustments you can turn the knob and it still clicks but the crosshair isnt moving anymore! their is only so much movement built into each scope! just a thought...
 
You must log in or register to reply here.
Back
Top Bottom