C8-Type Reciever milling?

Snake556

Snake556

New member
Rating - 0%
0   0   0
Location
Ont.
Hey guys, I've got a question for you! (Yes, I'm still alive, I just haven't been on here in quite a while!)

I was wondering if anyone knew of a place where I could have recievers milled from scratch? What I'm looking for is a C8 type reciever, but here's the catch (and most of you are gonna hate me for this one!): It's for a paintball gun, so it'll have to fit the internals of my gun. I won't go into specifics at the moment, since I've yet to see if anyone can actually do this :p

Thanks guys.
 
"...recievers milled from scratch..." Any machine shop can do it. Whether they will or not is another question. Be prepared to pay large dollars. Think in terms of $60 plus per hour. You will need complete drawings as well.
You'd best look into the legalities of it too. It could be construed to be manufacturing a firearm. CYA.
 
If it is just an upper, then it is not "manufacturing a firearm" at all....just a component of one......as long as you have the cash (and lots of it I suspect) and can find a shop to do it for you, go nuts.....
 
I am not a lawyer, nor do I play one on tv, but I think if you were to buy a raw casting from Dlask and have it machined to accept your paint gun internals you would not be breaking any laws.
 
You must log in or register to reply here.
Back
Top Bottom