Campro CMJRSFP 147GR 9mm w/titegroup

[HGee]

Hi,

Looking for a recipe for Campro 147gr 9mm CMJRSFP for a PCC. I'd like to use Titegroup for these but if someone has a recipe for CFE Pistol that would work too.

I don't know if these go by any other name but I haven't been able to find a recipe through search on here or anywhere else for that matter.

TIA

 

[hatman1793]

I think the TiteGroup load for Campro 147 9mm bullet is 3.2 grains.

 

[part timer]

Campro has all the reloading data on their website.

Might be worth a look. http://www.campro.ca/index.php?id=1023&family=9%20x%2019&produit=Cal.%209mm%20147gr%20RNFP%20FCP

Shows Titegroup Min/Max at 3.0/3.4, respectively. And CFE Pistol Min/Max at 3.7/4.2, respectively.

 

[FarmerDanz]

Most bullet makers suggest avoiding 147gr in a PCC.

I would load them on the hot side if you plan to try.

 

[HGee]

Thanks for the responses! Campro had deleted all their load data last time I checked, a few guys had mentioned it beforehand too. I should probably have checked there first ��

@FarmerDanz I'm not familiar with other PCCs but the ruger I use loves them.. I typically go 3.5-3.6 TG with them (RN Berrys) and the accuracy has been good too; last time I used it I actually shot the previous bullet I shot into the log I was using as a backstop, when I dug it out at first I thought it was a .50 muzzle load given the combined weight of the two melted together.. I'll post a pic of it a bit later, I still have the blob on my reloading table

 

[VICIOUS]

CAMPRO has relisted loads for there bullets, they up-dated the pages to look different.