Campro Ginex SP primers
- Thread starter snooker
- Start date
Very inconsistent in diameter in my experience. Some need to be pressed in so hard, that I instinctively close my eyes expecting them to explode. Some sit so loose that I think there was no primer fed. Same brass has been previously reloaded with CCI - no such problem. But they go bang reliably with stock triggers. Will yet try with my other guns having lighter springs.
I just picked up 20,000 of them, so I hope they work. Lol!
Slavex uses them a lot. He recently said elsewhere that he has loaded about 500,000 of them. They might be a snug fit in some brass, and I’ll find out when I get back to pistol loading.
Slavex uses them a lot. He recently said elsewhere that he has loaded about 500,000 of them. They might be a snug fit in some brass, and I’ll find out when I get back to pistol loading.
Theycallmejohnnycash
Member
- Location
- Moose Juice Saskachatoon Eh !
i find s&b brass to be tighter than all others. i reload 9mm and .45. i only seem to have trouble with s&b. i tried cci primers and had the same effect. otherwise they worked just fine for me.
I have tested them on various presses. Hornady they work great, dillons, if you use the alignment too first, they work fine in it too.
They are a little oversized, but due to their hardness the seat fine on 90% brass, you may have problems with non-swayed military brass.
They seem to be in the hardness level of the s&b
They are a little oversized, but due to their hardness the seat fine on 90% brass, you may have problems with non-swayed military brass.
They seem to be in the hardness level of the s&b
