Campro SRP in pistol cartridges
- Thread starter Redblack
- Start date
I loaded up some test rounds, 4grn of titegroup and Dominion small rifle primers with 124grn Campro round nose and 124grn Berry's hybrids.
They cycled my Canik and my PCC just fine.
Hitting paper pretty close to the factory blazer brass 124's
Your mileage may vary!
Sam
I've also used thousands of Dominion SRP in 9 mm pistol with no problems.
The western dealer of Dominion products said they were the same thing, under a different label.
I can't comment on any accuracy difference, 'cause I'm all over the place, with the best of ammo!
The western dealer of Dominion products said they were the same thing, under a different label.
I can't comment on any accuracy difference, 'cause I'm all over the place, with the best of ammo!
CCI 400 SRP - these are all I have used for the last year or so. I've had one FTF out of 10 - 15,000 I've used. Shooting a CZ Shadow2. Everything seats just right but they are a little harder then the CCI 500 SPP's so you would have to try it with your pistol to make sure they worked 100%.
What did you expect? CCI 400 is the same as 550. There are some SR primers that will present light strikes like CCI450, Rem 7.5 etc but most work just fine. I stopped buying SP primers years ago, stocking only Winchester or Federal SR just makes more sense logistically.
Dimensionally, SP and SR primers are the same (which is not the case for LP and LR primers). Therefore they should work fine as long as the firing pin strike is solid enough to detonate them which is typically the case except perhaps with some very light action competition guns (my PPC revolver only works reliably with Federal SP primers). Probably in 95% of all handguns they will work without issue.
