Can anyone I dentify these items?

[iron cat]

I take it the Lee case length trimmers are hand held? And are the shell holders to go into a drill? I have found any other Lee stuff yet. But haven't got through it all yet.

Top right holds your case, the bottom cutters and trimmers are either hand turned or chucked in a drill press and the case that is held by the lock stud is run into it.
Cat

 

[Meroh]

Those pointy rods are decapping pins for a sizing die.

The two round things above are the shell holder for an inertia pullet puller (like a hammer).

Actually, I'm thinking case trimmers. They have cutters on the top.

 

[I Dont Care About You]

Top right holds your case, the bottom cutters and trimmers are either hand turned or chucked in a drill press and the case that is held by the lock stud is run into it.
Cat

I always did it the other way round. The case holder is held in the drill chuck and the cutter is hand held and run into the case. Its kinda designed that way.

 

[M1-Garand]

I always did it the other way round. The case holder is held in the drill chuck and the cutter is hand held and run into the case. Its kinda designed that way.

That's the proper way to use them, the knurling on the cutters allows you to hold them with your fingers..

 

[iron cat]

I always did it the other way round. The case holder is held in the drill chuck and the cutter is hand held and run into the case. Its kinda designed that way.

Takes me a fraction of the time holding the case with the lock stud .
I glued the lock stud into a fat file handle, works super!
Cat