Can someone do quick load for 300wm 200gr. Accubond and ramshot magnum I need help

Mobeasto

Mobeasto

Regular
Rating - 100%
3   0   0
Hi there.. On Western powder website the load data for 200 gr( here they list partition and not accubond) is 84.4 max.. The only thing is that they list 83.8 as a Max for the 180gr (again partition and not accubond).. I wrote them about that and just answered me to use the one I want.. I find it a bit scary.. I then wrote to nosler but have no answer yet.. Can someone help me and do a quick load for me please.

300 win mag.
Coal 3.340"
Federal case
Br2 primers
Ramshot magnum powder
23.7" barrel.
1:11 twist rate
200 gr.. Accubond
63000-65000 psi max

This would. Be really helpful and a bit more safe than starting to high even if I get 10% off the Max it seem a bit high

Thanks in advance
David

P. S if you can include the list of the other recipe that quick load give in that range
 
Please confirm all data corresponds with your particular components i.e. actual bullet length and overflow case capacity (H2O) etc.
This load is at 99.9% powder fill rate so you are nowhere near the 62,366 psi maximum but, as always, proceed with caution and workup loads accordingly.

300WinMagF-78.0gRamshotMagnum-200gAccuBond_zpsppg8dzfc.jpg~original
 
You're never supposed to start at max so Western Powder was right to tell you to use whatever data you want, just make sure it's the START data and you'll be fine. 1/2 gr difference probably not the end of the world either way, regardless.
 
K-C said:
Please confirm all data corresponds with your particular components i.e. actual bullet length and overflow case capacity (H2O) etc.
This load is at 99.9% powder fill rate so you are nowhere near the 62,366 psi maximum but, as always, proceed with caution and workup loads accordingly.

300WinMagF-78.0gRamshotMagnum-200gAccuBond_zpsppg8dzfc.jpg~original
Click to expand...

Thanks a lot. Its appreciated. I sent you a pm
 
You must log in or register to reply here.
Back
Top Bottom