Close. Done.

-raqh-

-raqh-

CGN Regular
Rating - 100%
93   0   0
Location
East
Done.


I was looking for input on how to solidify an ATI strikeforce pistol grip to try and save it before I trash it for being so flimsy. Finally installed a bolt/nut offset and sideways to the original mounting screw.

It's now solid and I can go on with my soviet/chicom frankeinstein bubba build.

 
Last edited:
It's funny how only 20 guys looked at this thread and no one answered when I asked for advice.

Nothing against having fun, but it's a little sad you guys put more effort into this than helping and sharing thoughts and advices.


I was looking for input on how to solidify an ATI strikeforce pistol grip to try and save it before I trash it for being so flimsy. It's now solid and I can go on with my soviet/chicom frankeinstein bubba build.

 
Honestly, I still laughed when I found out how this turned out, just wish this thread would've generate that kind of response when I was picking my brain to find a decent solution.

The grip already had a bigger and longer vertical screw with an oversized head but I still found it weak. The cross side bolt helps a lot but, I might also be going with bolt/nut to replace the vertical screw.
 
You must log in or register to reply here.
Back
Top Bottom