Cooey Model 60 help
- Thread starter petster774
- Start date
- Location
- Winnipeg,Man.
There is an odd nut stud combination that holds the mag tube to the barrel, loosen this off and the tube will slide to release the bolt.
Removing bolt on Cooey model 600
Hi, if it is anything like the model 600 there will be a single screw on the bottom of the stock which secures it to the gun. Remove the screw which will alow you to remove the stock. Once the stock is removed you will see that the location where the first screw was threaded into is also a screw. Back it off enough to allow you to drop the tube about a quarter inch. Once this is done the bolt will be free to remove. Hope this helps!
froese2504
Hi, if it is anything like the model 600 there will be a single screw on the bottom of the stock which secures it to the gun. Remove the screw which will alow you to remove the stock. Once the stock is removed you will see that the location where the first screw was threaded into is also a screw. Back it off enough to allow you to drop the tube about a quarter inch. Once this is done the bolt will be free to remove. Hope this helps!
froese2504
- Location
- Winnipeg,Man.
The bolt is assembled under extreme pressure and needs a special tool to disassemble. this should be handled by an experienced gunsmith.
