Cooey/Savage/Lakefield 64 owners...request your help...

j-man

j-man

CGN frequent flyer
Rating - 100%
150   0   0
Location
YWG
Can anyone who owns a 64B pull out a set of calipers and take some easy measurements for me please? Specifically, I'm looking for the maximum width of the receiver (i.e. side to side), and the length of the receiver (i.e. from where the barrel meets the receiver to the back end of the receiver).

I don't have a 64B (yet), so I need a bit of help. Project time!:D

Thanks in advance.
 
Two additional measurements if you can:

Distance from back of the receiver to trigger; and
Distance from trigger to mag well.

Again, thanks for your time.
 
Got some measurements for you from my 64B, sorry they are in metric:

"Specifically, I'm looking for the maximum width of the receiver (i.e. side to side)" --- 2.16 cm

"length of the receiver (i.e. from where the barrel meets the receiver to the back end of the receiver)." --- 22.53 cm

Had a bit of difficulty with these last two measurements. They were measured to the best of my approximation only. Measured from that part of trigger finger touches.

"Distance from back of the receiver to trigger" --- 4.45 cm

"Distance from trigger to mag well." (trigger to back of magazine inserted in magwell)--- 10.55 cm
 
Last edited:
Boys, I really appreciate the help and thank you for taking the time. I just went out and bought an old Cooey 64 from a local dealer and am about to get chin deep, with another CGNer, in a project.

Hopefully we'll give this old girl, and a sister, a new lease on life.

J
 
You must log in or register to reply here.
Back
Top Bottom